Urethane-alkyd parquet varnish Carat Floor

Floor varnish with increased wear resistance. It has good elasticity and is applied without splashing and flow. The coating is resistant to abrasive wear, shocks and scratches, to most household chemicals, alcohols and hot water.

Packaging

1 L, 3 L, 10 L

Usage

Indoors

Gloss level

20 (semi-mat), 45 (silk-mat), 90 (glos)

Can be repainted at 23°C 50% RH

24 hr

Drying time, 23°С 50% RH

8 hr

Consumption

Sawn wood 6-8 m²/L, Planed wood 6-10 m²/L

Thinner

Mixon White Spirit, Mixon Solvent

Working tools

Roller, brush

Storage

3 years t > 0oC

Scope:

Suitable for varnishing wooden floors in medium-service rooms.

Surface preparation:

The lacquered surface must be dry and clean. It is necessary to remove the old lagging varnish from the previously painted surface, sand the surface to smoothness. The surface, previously covered with glossy varnish, should be polished to a matte to improve adhesion.

Priming:

The surface must be primed with Mixon Carat and Solve W in a ratio of 10:1.

Applying:

Mix thoroughly before application. Varnishing should be done in two layers with undiluted varnish. The required air temperature during application should be from +5°С to +30°С. Excessively high temperature in the room and draft can cause the formation of traces of overlap and a low-quality film of varnish. When working with a brush and roller, air should be avoided in the varnish layer. You should be careful in corners and other places where excess varnish may collect. In these places, use a small brush as a working tool. Before applying the layer, it is recommended to slightly sand the surface.

Technical specifications