Acrylic plaster Bark beetle А-100

Ready-to-work aqueous dispersion of acrylic resin and quartz. As a result of the application, a structural surface of bark beetles with a grain size of 2 mm or 3 mm is obtained. Plaster is resistant to atmospheric and mechanical influences. It has good elasticity and water-repellent properties.

Packaging

10 л/16 кг

Usage

Внутри и снаружи помещений

Grain

2.0 mm, 3.0 mm

Drying time, 23°С 50% RH

6-24 hr

Consumption

2.0 mm - 3 kg/m2 3.0 mm - 4 kg/m2

Thinner

Water

Working tools

Spatula

Storage

2 years t > 0oC

Фото

Scope:

It is intended for decorative and protective thin-layer coating in thermal insulation systems by the «light-wet» method using polystyrene foam. Eventually, the so-called «bark beetle structure is formed with a grain size of 2 mm, 3 mm. It is used on concrete, brick and plastered bases, as well as in thermal insulation systems of facades and on mineral wool during internal and external works.

Surface preparation:

The treated surface must be dry, cleaned of grease, dirt and lagging particles.

Priming:

The surface must be primed with an acrylic-silicone primer Mixon A100.

Applying:

Mix thoroughly before application. A small amount of water (0.1 L per bucket) can be added as needed. Gradually apply to the base with a steel grater at an angle of 60° to the surface. The thickness of the applied layer should correspond to the size of the aggregate grains. After the applied coating stops sticking to the tool, it is possible to form the structure of the plaster surface with a plastic grater. Depending on the time, intensity and trajectory of the grater, horizontal, vertical, circular or cross indentations can be obtained.

Attention: Protect from direct sunlight, wind and rain until it dries completely. Apply plaster to cement, cement-lime, concrete bases after 28 days of natural drying of the base.

Technical specifications